Head Pins

[Solitaire]

Why are some head pins so hard to bend into shape ? My fingers are so sore.

[Peter]

You've got good 'uns! Be grateful! If I get cheap ones I use them as links rather than headpins, sore fingers?.............you do use pliers do you? :)

[Solitaire]

:mf: yes I do, but when you bend the wire sideways over the bead I use my thumb nail to lean the wire and pliers to make the loop. :mf:

[Peter]

Ah, that explains it! I use the tip of long nose pliers to bend over the bead then round nose to loop. Do you leave 3-5mm from the bead to the bend? It gives you room to get the pliers in! :)

[Solitaire]

About that, would rather the wire was too long so I can snip bits off than too short and have to start again

[Peter]

No, I meant from the top of the bead where the wire comes out, don't bend flat to the bead, but leave 3-5mm before bending at right angles and then looping. :)

[Solitaire]

Sorry no I bend it left to the top of the bead

[Peter]

Try a thimble..................:D

[silverthistlebeads]

You can get hard pins, usually about 28 gauge metal and soft pins that are about 21 gauge, at least thats what I have and the 21 are much easier to bend.

The only thing I find is depending on what I am making the 21 gauge can be too soft and the 28 really hard to bend.

Francesca

[naomi126]

I use an old metal thimble that ive bent into a point..saves sore fingers and nails!

[Beadservice]

It depends on the thickness of the head pin and what the base metal is.

I sell both 0.7mm and 0.5mm diameter pins, which are from Beadalon, with real 'silver plating' and easy to use.

I know what you mean though...when I first started making, I used some cheap head pins. They were really tough to bend and I ended up with grooves in my thumb nails.

Debbie