MADHR
12-04-2010, 03:42 PM
Hi!!
First of all, I have to apologize for my poor english. I will try to do my best :P
I am trying to glue clear glass cabs to paper images using Diamond Glaze. It didn't seem very difficult, but the first problem is here...
I use a paint brush to apply a thin layer of Diamond Glaze over the paper (common paper). Then, I put the cab over the image (I use a laserjet printer) in a flat table and then I push the cab against the paper.
No matter what I do: press the image with my finger, give a wipe, even my fingernails!
I always get tiny ¿bubbles?.
After few seconds, When the glue start to dry, they look like teeny metallic colour marks, not like "typical bubbles" nor blurred ink. They are not very visible if you look the cab ahead, you can see them sideway...
Does anybody know what it's wrong?
Thanks in advance!
First of all, I have to apologize for my poor english. I will try to do my best :P
I am trying to glue clear glass cabs to paper images using Diamond Glaze. It didn't seem very difficult, but the first problem is here...
I use a paint brush to apply a thin layer of Diamond Glaze over the paper (common paper). Then, I put the cab over the image (I use a laserjet printer) in a flat table and then I push the cab against the paper.
No matter what I do: press the image with my finger, give a wipe, even my fingernails!
I always get tiny ¿bubbles?.
After few seconds, When the glue start to dry, they look like teeny metallic colour marks, not like "typical bubbles" nor blurred ink. They are not very visible if you look the cab ahead, you can see them sideway...
Does anybody know what it's wrong?
Thanks in advance!