Ads

Collapse

palston pots????

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • sweetcheeks
    Junior Member
    Junior crafter
    • Mar 2009
    • 4

    palston pots????

    just starting off and found a thread recommending palston pots to use to melt the wax. can anyone tell me how this works as thought you needed water to melt????. also do you add the perfume and colouring to the palston pot, or should it be added at another time. hope this makes sense.
  • cinnamonchic
    Member
    Moderate crafter
    • Dec 2008
    • 30

    #2
    You only need water if you are using double boiler methods to stop the wax heating too hot too fast. For the palson pot, the heater is underneath the pot and it is controlled by a thermostat to stop it heating up too much so no water needed.

    You switch it on, set the temperature and just throw everything you want to in the pot, wax, scent, colour if you wish.

    I tend to add colour and scent in the pouring jug, but doing it in the post is perfectly ok. To clean it, just warm it up and wipe it down the inside with kitchen roll.

    Fantastic pots.
    ------------------------------------------------
    My Online Store

    http://www.scentedpillarcandles.co.uk

    http://www.handmadepromises.com

    http://www.makecandles.co.uk

    http://www.candlesscents.co.uk

    Comment

    • Bowed Over
      Senior Member
      Try and catch up with this one.. What a crafter!!!
      • Feb 2007
      • 6372

      #3
      Got a couple of the palston pots myself and they are fantastic. Got hubby to add a couple of taps to them so I can just pour out the melted wax. Like cinnamonchic says the element is underneath the pot and never comes into contact with the wax.

      I mix my scent and colour in a pouring jug just in case.

      Cheers.

      Lisa

      Bowed Over
      Handmade Dog Collar Accessories
      www.bowedover.co.uk

      Comment

      • Oddsox
        Senior Member
        100+ crafts club
        • Nov 2008
        • 407

        #4
        As a recent convert to the Palson Pot I agree with all above. Use mine all the time although scent is put in out of the pot (once it has cooled a bit).

        Great little tool and much more effective than the double boiler method.

        Oddsox

        Comment

        • sweetcheeks
          Junior Member
          Junior crafter
          • Mar 2009
          • 4

          #5
          Thank you

          Thank you all for your great advice

          Comment

          • Critchley
            Super Moderator
            Super mega humungous crafter with too much time on their hands and chats too much!
            • Jun 2008
            • 18988

            #6
            niceto see you. Hope you decide to stay.
            Carol
            God helps them that help themselves.

            Comment

            • tigersumpy
              Junior Member
              Junior crafter
              • Apr 2009
              • 13

              #7
              Re Palston Pot

              What is the lowest temp on the thermostat on one of these pots?

              I reckon i'm being thick here but what is the difference to putting the wax in a pan and sticking it on the heat or using one of these cos either way the wax isn't in direct contact with the heat?

              Comment

              • Bowed Over
                Senior Member
                Try and catch up with this one.. What a crafter!!!
                • Feb 2007
                • 6372

                #8
                Thermostat is the difference. As you know wax has a flash point so you walk away from the kitchen to answer the phone if the wax is on the heat "BOOM" if using the pot the thermostat kicks in and keeps the wax at a constant temp.

                HTH.

                Lisa
                Bowed Over
                Handmade Dog Collar Accessories
                www.bowedover.co.uk

                Comment

                • JohnP
                  Member
                  Moderate crafter
                  • Feb 2009
                  • 43

                  #9
                  Has anyone ever had a wax fire? I imagine it would be pretty dangerous, like a chip pan fire.

                  I did a search on the internet to try and find the temperature at which it ignites. I found 199 celcius. Which is pretty hot!

                  Still, I'm absent minded, so I hardly ever melt wax on the stove. I melt it in a pan resting in boiling water instead.

                  Comment

                  • cinnamonchic
                    Member
                    Moderate crafter
                    • Dec 2008
                    • 30

                    #10
                    Hi John - a wax fire is just like a chip pan fire.

                    The flash points are all different and although some of them may look high, there can be different problems if fragrance is added on heat as well. Mega boom.

                    The problem being that the melt point of waxes is quite low but once the wax has melted, the speed at which it gets hot enough to flash is phenomenal - you could pop to the loo when there is still wax in the pot melting and the boom could happen in the minute or two you are gone.

                    What you are doing, ie pan in pan is much safer as the wax can only get as hot as the temperature of boiling water it is sitting in. The danger here is that if the water boils off and you don't notice - again kaboom.
                    ------------------------------------------------
                    My Online Store

                    http://www.scentedpillarcandles.co.uk

                    http://www.handmadepromises.com

                    http://www.makecandles.co.uk

                    http://www.candlesscents.co.uk

                    Comment

                    • tigersumpy
                      Junior Member
                      Junior crafter
                      • Apr 2009
                      • 13

                      #11
                      re palston pot

                      Originally posted by candles by lisa View Post
                      Thermostat is the difference. As you know wax has a flash point so you walk away from the kitchen to answer the phone if the wax is on the heat "BOOM" if using the pot the thermostat kicks in and keeps the wax at a constant temp.

                      HTH.

                      Lisa
                      Silly question but do you put another pot inside it to save having to wash it out or just use it as is?

                      Tigersumpy

                      Comment

                      • girlyracer
                        Senior Member
                        100+ crafts club
                        • Oct 2007
                        • 340

                        #12
                        I use mine as is. Just chuck the wax in and I then ladle out the required quantity into a jug, add colour (optional), add fragrance, then stir and pour
                        Ruby xx



                        Website - Cosy Candles & Aromas
                        Blog - Ruby's Crafty Diary
                        Facebook Page

                        Comment

                        • tigersumpy
                          Junior Member
                          Junior crafter
                          • Apr 2009
                          • 13

                          #13
                          thanks for that

                          Comment

                          • JohnP
                            Member
                            Moderate crafter
                            • Feb 2009
                            • 43

                            #14
                            Actually that happened to me once (all the water evaporated).

                            I'm super careful now though.

                            I would get some Palston pots, but they cost a bomb.

                            Comment

                            • girlyracer
                              Senior Member
                              100+ crafts club
                              • Oct 2007
                              • 340

                              #15
                              Originally posted by JohnP View Post
                              Actually that happened to me once (all the water evaporated).

                              I'm super careful now though.

                              I would get some Palston pots, but they cost a bomb.
                              I wouldn't call £33 a bomb especially if you're looking to take it up as a serious hobby or thinking of turning your hobby into a part time biz. Look at it as an investment.

                              You can get them from here http://www.redumbrella.co.uk/product...ge.php?id=1063

                              and you get free delivery.
                              Ruby xx



                              Website - Cosy Candles & Aromas
                              Blog - Ruby's Crafty Diary
                              Facebook Page

                              Comment

                              Working...
                              X